Ground shafts

Precision ground round shafts in standard metric and inch diameters and lengths, to go with your gears. They ship with your printed parts. A gear with a set-screw hub (the generator's standard) locks onto them.

Material303 stainless steel; 3, 4 and 5 mm in carbon steel
FinishGround
Diameter toleranceMetric −0.005 to 0 mm (stainless); inch −0.0005 to 0"
LengthsMetric 100, 200 and 400 mm; inch 4, 6 and 12"
AvailabilityIn stock where a price is shown
LengthØ, groundChamfered ends

Metric shafts

Part number by diameter and length

Diameter100 mm200 mm400 mm
2 mmD-flat: 1.5 mm acrossPG-SM2-100PG-SM2-200PG-SM2-400
3 mmD-flat: 2.5 mm acrossPG-SM3-100PG-SM3-200PG-SM3-400
4 mmD-flat: 3.5 mm acrossPG-SM4-100PG-SM4-200PG-SM4-400
5 mmD-flat: 4.5 mm acrossPG-SM5-100PG-SM5-200PG-SM5-400
6 mmD-flat: 5.5 mm acrossPG-SM6-100PG-SM6-200PG-SM6-400
8 mmD-flat: 7.5 mm acrossPG-SM8-100PG-SM8-200PG-SM8-400
10 mmD-flat: 9 mm acrossPG-SM10-100PG-SM10-200PG-SM10-400
12 mmD-flat: 11 mm acrossPG-SM12-100PG-SM12-200PG-SM12-400

Inch shafts

Part number by diameter and length

Diameter4"6"12"
1/8"D-flat: 0.105" acrossPG-SI125-4PG-SI125-6PG-SI125-12
3/16"D-flat: 0.168" acrossPG-SI188-4PG-SI188-6PG-SI188-12
1/4"D-flat: 0.230" acrossPG-SI250-4PG-SI250-6PG-SI250-12
5/16"D-flat: 0.293" acrossPG-SI313-4PG-SI313-6PG-SI313-12
3/8"D-flat: 0.345" acrossPG-SI375-4PG-SI375-6PG-SI375-12
1/2"D-flat: 0.470" acrossPG-SI500-4PG-SI500-6PG-SI500-12

Fitting a printed gear to a shaft

On a round shaft, give the gear a set-screw hub: the generator's standard hub has a brass heat-set insert and a cup-point set screw, so the screw bears on the shaft without threading into the nylon. Choose the shaft size under Hub & bore and leave the fit at Sliding. For a motor with a D-flat shaft, choose a D-flat bore instead.

Making your own D-flat. With a surface or bench grinder you can grind a flat on any of these shafts. Grind it to the across-flat size shown under each diameter, the standard D-shaft size, at least as long as the gear's bore and hub, and break the edges. Then choose a D-flat bore of that diameter in the generator: its bore matches that flat. A D-flat carries more torque than a set screw on a round shaft, and the set-screw insert sits over the flat. More in Mounting nylon gears.

Design a gear for your shaft