Ring gears and planetary sets

A ring gear, or internal gear, has its teeth on the inside. Its pinion runs inside it and turns in the same direction, on a short center distance.

Figure 1. A 48-tooth ring gear and its 15-tooth pinion.

Geometry

a = m (z₂ − z₁) / 2

The teeth of a ring gear are concave, so more teeth are in contact than in an external pair, and the contact stress is lower. Ring gears cannot be cut with a hob. They are made with a pinion-shaped shaper cutter, and the generator simulates exactly that process to produce the tooth form.

Avoiding interference

If the ring has too few teeth more than its pinion, the tips of the two gears collide as they come out of mesh. Keep the difference at least 10 teeth for 20° gears. Even then, the ring's tips can reach below the start of the pinion's involute; the generator can shorten the ring tips just enough to prevent this.

Planetary gear sets

A planetary set combines a sun gear, several planets and a ring (Figure 2). It is compact, coaxial and shares the load between the planets, which is why it is used in gearmotors, wheel hubs and automatic transmissions.

Sun, 15 teethPlanet, 15 teeth (3)Ring, 45 teeth
Figure 2. A planetary set: 15-tooth sun, three 15-tooth planets and a 45-tooth ring.

z_ring = z_sun + 2 z_planet    ratio with the ring fixed = 1 + z_ring / z_sun

For equally spaced planets, (z_sun + z_ring) divided by the number of planets must be a whole number. The set in Figure 2 gives 4 : 1 with the ring held and the output taken from the planet carrier.

Design a ring gear and pinion. The generator picks the shaper cutter and checks for interference. Open the generator.