Replace a broken gear
When a plastic gear strips in an appliance, a toy or an old machine, the part is often no longer made. Measure the old gear, and the generator draws a new one that meshes with the gears still in the machine. We print it in SLS nylon, or you can download the files free.
Match my gear in the generator
How to measure it
You need calipers and a few minutes
Count the teeth
Mark one tooth with a pen and count around. If teeth are missing, count the gaps they left as well. On the mating gear, count its teeth too: you'll need them if you replace both.
Measure across the tips
With an even number of teeth, measure across two opposite tips. With an odd number, the tips aren't opposite: measure from one tip to the far side of the bore. The tip diameter is twice that, minus the bore diameter. Measure where the teeth are least worn.
Let the generator find the module
Open Match an existing gear in the generator and enter the tooth count and tip diameter. It lists the closest standard metric modules and inch diametral pitches. If none is close, the gear may have a profile shift; the generator suggests one.
Check the pressure angle
Almost all modern gears are 20°. Older inch gears are often 14.5°, with narrower, straighter-sided teeth. If the new gear is for an old machine and runs rough, try 14.5°.
Measure the bore, hub and width
Measure the shaft, not the worn bore. Note any flat (choose a D-flat bore), a key, or a knurl (choose a press fit). Measure the toothed width and any hub. A gear that was held by a pin or glue can use a hub with a set screw instead.
Look at the mating gear
If its teeth are worn too, replace both as a gear pair, set to the same center distance as the original shafts.
Common sizes in appliances
What to expect
| Metric modules | 0.5, 0.6, 0.75, 0.8 and 1 are the most common in small appliances, toys and office machines; 1.25 to 2 in power tools and garden equipment. |
| Inch pitches | 32, 48 and 64 DP in older American equipment, instruments and models. |
| Metric or inch? | Tip diameter ÷ (teeth + 2) gives the module in mm. If it comes out near 0.53 or 0.79 rather than a round number, the gear is probably 48 or 32 DP. |
| Material | Most original small gears are acetal or nylon. SLS nylon 12 is usually as strong; for a gear that was meant to fail first, consider whether something else jammed. |
Examples
Open one and change it to match your gear
Compound gear from a small appliance
A 47-tooth wheel with an 11-tooth pinion on the same body, module 0.75, on a 3 mm shaft: the kind of gear that strips in ice cream makers, food processors and fan oscillators.
Open in the generatorSmall spur gear on a motor shaft
Module 0.5, 40 teeth, with a D-flat bore for a 3 mm motor shaft, as in printers, toys and small gearmotors.
Open in the generatorGear with a set screw
Module 1, 30 teeth, on a 5 mm round shaft, with a hub and a brass insert for a set screw. A common way to remake a gear that was pinned or glued.
Open in the generatorCan't measure it?
Email orders@protogears.com with photos of the gear next to a ruler, the tooth count, and what machine it came from. We'll work out the gear and send you a link to the design.
We don't make worm gears yet, and printed parts aren't certified for food contact, which doesn't matter for a gear inside a gearbox.