Hubs and bores for plastic gears
Nylon is soft, and it slowly creeps under steady load. Shaft connections that grip by shape or by clamping work well. Connections that rely on a thread in the plastic, or on the friction of a tight fit, loosen over time.
Connections that work well
- D-flat and double-D. The usual choice for motor and stepper shafts. Torque is carried by shape, so creep matters little. Two flats are better than one under reversing loads.
- Hex and square. The most torque-tolerant drive for printed gears: a large contact area, and hex shaft is cheap.
- Bolt circle onto a metal hub. For high torque, let a metal hub carry the shaft and bolt the nylon gear to it. Use washers or a backing plate to spread the bolt load.
Connections to use with care
- Keyways. Work at moderate torque. Nylon cannot take much bearing pressure on the side of the key, so use a longer hub to give the key more length. The generator sizes keys to DIN 6885 or ANSI B17.1.
- Set screws. Only with a captured nut or a threaded insert, with the screw bearing on a flat on the shaft. Screwed straight into nylon they strip or back out.
Connections to avoid
- A plain round bore held by a press fit. The fit relaxes within weeks under load. It is acceptable only for light loads, or with adhesive or a knurled shaft.
- Threads tapped into the nylon for anything that carries load.
Bore allowance
Laser-sintered holes come out slightly small. The generator adds a bore allowance to the bore, flats and keyway; about +0.1 to +0.2 mm gives a sliding fit on a ground shaft.
Every gear type can have any of these bores, a hub on one or both faces, bolt holes or spoke windows. Open the generator.