Helical gears

Helical gear teeth are cut at an angle to the axis. Each tooth enters the mesh gradually, from one end to the other, so helical gears run more quietly and carry more load than spur gears of the same size.

Figure 1. A helical gear: front view and side view. The side view shows the teeth crossing the face at the helix angle.

Helix angle and hand

The helix angle β is measured between a tooth and the gear axis on the pitch cylinder. Typical values are 10° to 25°; above about 30° the axial force becomes large. A right-hand helix slopes like a standard screw thread. Gears on parallel shafts must have the same helix angle and opposite hands.

Normal and transverse module

A helical gear has two pitches. The normal pitch is measured square to the teeth, and is the pitch of the cutter that makes it. The transverse pitch is measured in the plane of rotation, around the gear. Unrolling the pitch cylinder shows the relationship (Figure 2).

Transverse pitch pt = pn / cos βNormal pitch pn = π mnβFace width b
Figure 2. Helical teeth unrolled from the pitch cylinder. The normal pitch is square to the teeth; the transverse pitch runs around the gear.

mt = mn / cos β    d = mn · z / cos β    tan αt = tan αn / cos β

When you enter a module in the generator's helical modes, it is the normal module. A 24-tooth gear of normal module 1 at 20° has a pitch diameter of 25.54 mm, not 24 mm, and the standard center distance of a helical pair grows by the same factor 1 / cos β. This is useful: by choosing the helix angle you can fit a pair to almost any center distance without profile shift.

Overlap ratio

Because the teeth are inclined, more than one tooth shares the load even across the face width. The overlap ratio measures this:

εβ = b · sin β / (π mn)

The total contact ratio is the transverse contact ratio plus the overlap ratio. An overlap ratio of 1 or more gives the smoothest running; the generator reports both.

Axial thrust

The inclined teeth push the gear along its shaft. The axial force is Fa = Ft · tan β, where Ft is the tangential force at the pitch circle. At β = 20° the thrust is 36 % of the tangential force, so the bearings and the hub must be able to take it. The generator's load rating shows the axial force for your torque. Double-helical (herringbone) gears cancel the thrust by using two opposite helices side by side.

When to choose helical gears

  • High speeds, where spur gear noise would be objectionable
  • Higher load in the same space
  • Center distances that would otherwise need large profile shifts

Helical gears on crossed shafts (same hand, shafts at 90°) are a different design with point contact and light load capacity; the generator does not make them.

Design a helical pair, and the generator gives gear 2 the opposite hand automatically. Open the generator.