Spur gears
A spur gear has straight teeth parallel to its axis. It is the simplest gear to design, make and inspect, and the right choice for most drives between parallel shafts.
Why the teeth are involutes
Almost every gear made today has involute teeth. An involute is the curve traced by the end of a taut string as it unwinds from a circle, called the base circle (Figure 1). Wherever two involute teeth touch, the force between them acts along a line tangent to both base circles. That line does not move, so the gears turn at a perfectly constant speed ratio.
Involute gears have a second property that matters in practice: if the center distance comes out a little larger than intended, the ratio does not change. Only the backlash and the operating pressure angle change. This tolerance to mounting errors is why the involute displaced every other tooth form.
Module and diametral pitch
Tooth size is given by the module in metric practice and by the diametral pitch in inch practice. The module is the pitch diameter in millimetres per tooth; diametral pitch is teeth per inch of pitch diameter. Two gears mesh only if they have the same module (or diametral pitch) and the same pressure angle.
d = m · z P = z / d m = 25.4 / P
A 30-tooth gear of module 1 has a 30 mm pitch diameter. A 24-tooth gear of 32 diametral pitch has a 0.75 in pitch diameter, and 32 DP is very close to module 0.8.
Pressure angle
The pressure angle is the angle between the line of action and the tangent to the pitch circle. It sets the shape of the tooth: a larger angle gives a broader, stronger tooth base and fewer problems with undercut, at the cost of higher bearing loads. 20° is the modern standard. 14.5° is found on older inch-system gears, and 25° is used where strength matters most.
Standard tooth dimensions
| Dimension | Symbol | Standard value (ISO 53, AGMA full depth) |
|---|---|---|
| Pitch diameter | d | m z |
| Addendum | ha | 1.0 m |
| Dedendum | hf | 1.25 m |
| Whole depth | h | 2.25 m |
| Tip diameter | da | m (z + 2) |
| Root diameter | df | m (z − 2.5) |
| Base diameter | db | d cos α |
| Circular pitch | p | π m |
| Root clearance | c | 0.25 m |
The extra 0.25 m of dedendum is clearance, so the tips of the mating gear never touch the root. With profile shift (see Gear pairs) the tip and root diameters each grow by 2 x m.
How few teeth can a gear have?
When a gear with few teeth is cut by a rack, the cutter's tip removes material from the lower flank of each tooth. This is called undercut. It thins the root, weakens the tooth and shortens the working part of the involute. For standard teeth the minimum count without undercut is
zmin = 2 / sin² α which gives 17 teeth at 20°, 32 at 14.5° and 12 at 25°
In practice 14 teeth at 20° is fine for most work. Below that, add positive profile shift, which the generator does for you in pair mode.
Where spur gears are used
Spur gears run in gearmotors, printers, robots, instruments, timers and countless machine drives. They are efficient (often above 98 % per mesh with metal gears), produce no axial force, and are easy to measure. Their weakness is noise at high speed, because each tooth picks up its load at once. Where that matters, use helical gears.
The generator draws the exact tooth, reports undercut and gives measurement over pins for inspection. Open the generator.