Racks and pinions
A rack is a gear of infinite radius: a straight bar of teeth. Driven by a pinion, it turns rotation into straight-line motion.
The basic rack
The rack has straight flanks at the pressure angle, and it defines the whole gear system. ISO 53 specifies the basic rack profile shown in Figure 2: addendum 1 m, dedendum 1.25 m and a root fillet of 0.38 m for profile A. Every gear cut by the same rack meshes with every other, and with the rack itself.
Travel and mounting
travel per pinion turn = π · m · z pinion center above rack back = H + d/2 + x m
Here H is the distance from the rack's pitch line to its back. A 16-tooth pinion of module 1 moves the rack 50.27 mm per turn. Set the pinion height carefully: too high and backlash grows; too low and the teeth bind.
Long racks
Printed racks are limited by the build size; ours go up to 220 mm. For longer travel, mount racks end to end so the tooth spacing across the joint is a whole number of pitches. A short piece of rack pressed into both ends works as a gauge while you tighten the screws.
Design a rack and pinion; the generator reports travel per turn and checks the mesh. Open the generator.