What to expect from printed nylon gears

A laser-sintered nylon gear is a real, working gear: the generated tooth form, a tough engineering plastic, and no tooling cost. It is not a precision gear. Knowing where it sits lets you use it where it shines and avoid the jobs it will disappoint in.

The quality you get

  • Dimensions. Print services commonly quote about ±0.3 % of a dimension, with a floor of ±0.3 mm. Small features come out slightly small, which is why the generator adds allowances to bores and recommends backlash.
  • Tooth form. The involute is traced exactly by the laser, but the edges are softened by the powder grain, so expect slightly rounded tips and roots. Coarse teeth reproduce better than fine ones; below about module 0.5 the error becomes a large part of the tooth.
  • Runout and pitch errors. Larger than a cut gear’s. A printed pair runs smoothly at modest speed, with more backlash and a little more noise than machined gears.
  • Surface. A matte, slightly grainy finish that wears in quickly. It holds grease well.
  • Consistency. Parts from the same build are very alike. Between builds, expect small changes in size from powder and machine condition; tight-fit parts are best ordered together.

In short: think of the quality of a good molded plastic gear, without the mold. It is a long way from a ground steel gear.

Good applications

  • Prototypes and proof-of-concept mechanisms, where you want the real gear in your hands in days.
  • Robotics, automation fixtures, camera and telescope drives, lab instruments and hobby machines at light to moderate load.
  • Replacement gears for appliances, printers and equipment that are no longer made.
  • Low-speed drives, indexing and positioning where some backlash is acceptable, or is taken out with a spring.
  • Quiet, lubrication-free running against a metal or nylon mate, and parts that see oils, greases and fuels, which nylon 12 tolerates well.
  • Low-volume production, up to a few hundred parts, where a mold isn’t worth it.

Applications to avoid

  • High precision. Anti-backlash instrument drives, precision indexing, or anything that needs a stated gear quality grade. Use a cut or ground metal gear.
  • High torque or shock. Teeth are rated in the generator; if a nylon gear needs a large safety factor to pass, use metal. Nylon also creeps under steady load, so avoid gears that hold a load for long periods without moving.
  • High speed. Above about 5 m/s at the pitch line, unlubricated plastic gears heat up and wear quickly.
  • Heat. Nylon softens well below its 176 °C melting point. Keep loaded gears clear of motors, engines and other hot spots.
  • Safety-critical drives. Brakes, lifting, steering, anything where a broken tooth could hurt someone.
  • Fine pitches. Very small modules and fine belt pitches are near the limit of the process; the generator flags or refuses them.

Getting the most from a printed gear

  • Use the load rating in the generator, with a safety factor of at least 1.5 for steady loads and more for shock.
  • Pair a printed gear with a metal or acetal mate where you can: wear is lower than nylon on nylon.
  • Give it backlash (0.05 mm per gear or more) and a sliding fit on the shaft, held by a set screw in a brass insert or a D-flat.
  • Run it with a light grease compatible with plastics if the duty is continuous.
  • Order one first when the fit matters, then order the rest once it checks out.

Design a spur gear and check its load rating in nylon. Open the generator.