Gear pairs, center distance and profile shift
Two gears that mesh must share the same module and pressure angle. Their tooth counts set the ratio; the center distance and the profile shifts decide how well they run.
Ratio and standard center distance
i = z₂ / z₁ = n₁ / n₂ a₀ = m (z₁ + z₂) / 2
A 14-tooth pinion driving a 30-tooth gear gives a ratio of 2.143 : 1, and at module 1 the standard center distance is 22 mm. Figure 1 shows a pair in mesh. Contact between the teeth happens only along the line of action, between the points where it crosses the two tip circles.
Contact ratio
The contact ratio is the average number of tooth pairs in contact: the length of the path of contact divided by the base pitch. It must be greater than 1 so that the next pair of teeth picks up the load before the last one lets go. Aim for at least 1.2; standard spur gears usually reach 1.4 to 1.8. The generator calculates it over the true involute, so undercut and tip rounding are taken into account.
Profile shift
Profile shift moves the cutter away from (positive) or toward (negative) the gear center while the teeth are generated, by x times the module. The teeth are still involutes on the same base circle, but a different part of the involute is used (Figure 2). Positive shift thickens the root, removes undercut and enlarges the gear slightly.
Shift is the tool for fitting a pair to a center distance that is not standard. If the total shift x₁ + x₂ is not zero, the operating pressure angle changes:
inv αw = inv α + 2 tan α · (x₁ + x₂) / (z₁ + z₂) a = a₀ · cos α / cos αw
where inv α = tan α − α. Given the center distance you need, the generator solves these equations for the total shift and splits it between the gears, giving the smaller gear enough to avoid undercut. It then shortens the tips if needed to keep the standard 0.25 m root clearance.
Backlash
Backlash is the play between the teeth: how far one gear can turn while the other is held. A little is always needed, for manufacturing tolerances, thermal expansion, lubricant and, with nylon, moisture swelling. Printed nylon gears at module 1 typically need 0.05 to 0.1 mm per gear. The generator thins each tooth by the amount you enter and reports the resulting backlash for the pair.
Enter the center distance you need and the generator works out the shifts and checks contact ratio, backlash, clearance and interference. Open the generator.