Straight bevel gears
Bevel gears connect shafts whose axes meet, most often at a right angle. Their teeth are cut on cones instead of cylinders, so every tooth tapers from a large end (the heel) toward the point where the two shaft axes cross.
Pitch cones
Each gear rolls on a pitch cone. The two cones touch along a line and share their tip, the apex. For shafts at 90° the cone angles follow directly from the tooth counts:
tan δ₁ = z₁ / z₂ δ₂ = 90° − δ₁ cone distance R = m √(z₁² + z₂²) / 2
The module m is given at the heel. Toward the small end (the toe), every dimension of the tooth shrinks in proportion to its distance from the apex. Keep the face width under about a third of the cone distance, or the teeth at the toe become too small to carry load or to print cleanly.
The tooth form
A bevel tooth's exact profile is a spherical involute. The generator uses Tredgold's approximation, the standard basis of bevel gear design: at the heel the teeth are those of a virtual spur gear with z / cos δ teeth, laid on the back cone. Each section toward the toe is the heel section scaled toward the apex. For a 16-tooth pinion meshing with a 32-tooth gear, the virtual tooth counts are about 18 and 72, which is why a bevel pinion undercuts less than a spur gear with the same number of teeth.
Profile shift
Bevel pairs normally use equal and opposite profile shift: the pinion gets +x and the gear −x, so the cone angles and mounting distances don't change. This strengthens the pinion, which runs more often, and balances wear. The Gleason recommendation for a pair at 90° is
x₁ = 0.46 (1 − z₁² / z₂²) x₂ = −x₁
Mounting distance
Bevel gears only mesh correctly when both pitch cones share the same apex. The mounting distance is the distance from that apex, which lies on the other gear's axis, to the gear's back face. The generator reports it for each gear. Set it with shims or a shoulder on the shaft. A bevel pair that is mounted too deep binds, and one mounted too shallow runs with extra backlash and loads only the tips.
In printed nylon
Laser-sintered bevel gears suit light-duty right-angle drives, prototypes and replacement parts. The thrust from the conical teeth pushes each gear away from the apex, so support the gears axially, for example with a shoulder behind the back face and a collar or thrust washer.
Design a bevel pair. The generator works out the cone angles, mounting distances and recommended profile shift. Open the generator.